BMR SB031H Sway Bar Kit w/Bushings Front Sb020h & Rear Sb021h

Sway Bar Kit w/Bushings, Front (SB020) & Rear (SB021)
The two primary functions of sway bars are to control body roll & to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspensions SB031 front & rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, & adjustability requirements. Manufactured from heavy-duty solid 1.25-inch bar stock (front), & 1-inch bar stock (rear), the SB031 is cold formed to better resist torsional fatigue & retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bars are CNC-formed for exact manufacturing tolerances & repeatable high quality. The front sway bar mounts to the car using polyurethane bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, & are internally fluted to keeps grease in the bushing. The steel sway bar mounting brackets are reinforced to minimize deflection.BMR Suspension designed this sway bar kit for street performance, autocross, & road race applications. The SB031 sway bars give you a massive increase in sway bar rate. These rate increases allow you to drive harder through corners w/minimal body roll. The SB031 front sway bar attaches to your G-body w/88-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. This allows for more sway bar control, & more control equals better handling. When performance is a must, rely on BMR Suspension!BMR Suspensions SB031 sway bars are available in black hammertone & red powdercoat for long-lasting good looks. Installation time is about 3-4 hours. Proudly made in the U.S.A.!