BMR SB039R Sway Bar Kit w/Bushings Front SB038 & Rear SB033

Sway Bar Kit w/Bushings, Front (SB038) & Rear (SB033)
The two primary functions of sway bars are to control body roll & to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspensions SB039 front & rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, & adjustability requirements. Manufactured from heavy-wall 29mm (front) & 32mm (rear) DOM tubing, the SB039 is cold formed to better resist torsional fatigue & retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances & repeatable high quality. Thrust washers are welded to the bar to locate the sway bar bushing mounts. This is critical as it properly locates the sway bar & prevents lateral movement during hard cornering maneuvers. The sway bar mounts to the car using polyurethane bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, & are internally fluted to keeps grease in the bushing. The steel sway bar mounting brackets are reinforced to minimize deflection. The sway bar is 3-way adjustable to tune the amount of torsional spring rate & to determine the handling characteristics (understeer/oversteer) of the vehicle.BMR Suspension designed the SB039 sway bar for street performance, autocross, & road race applications. The large adjustable sway bars three positions give you the versatility to drive to & from the road course or autocross & still out handle the competition w/the same sway bar. The SB039 sway bars give you a 98%-214% increase (front) & a 25%-200% increase (rear) in sway bar rate. These rate increases & adjustability allow you to fine-tune the handling characteristics of your Camaro so you can drive harder through corners w/minimal body roll.