UMI Performance 4061 Steering Bump Steer Assembly

UMI’s A-body bump steer kit (1964-1970) is designed to reduce or eliminate toe change during suspension travel (also known as “bump steer”). Reduction of bump steer improves handling and straight line stability and enhances overall precision of the steering system. These direct bolt-in kits allow the builder to relocate the outer tie rod end lower than stock (or higher if necessary). The stud taper is designed for exact factory fit for each application and is constructed of 4140 CrMo for strength and durability, no spindle drilling required. The adjuster is 6061-T6 Aluminum hex for lightweight strength and features a hard anodized protective finish. Kits include shims of 0.125”, 0.1875” and 0.250”. These race-tested bump steer kits are 100% designed and manufactured with pride in Philipsburg, PA – USA.\nFeatures:\n4140 CrMo stud construction.\nRace quality rod end, jam nuts and locking hardware.\nLaser cut spacers, of 0.125”, 0.1875” and 0.250”.\n6061-T6 Aluminum toe adjuster, hard anodized, 5/8 RH and 5/8 LH threads, 9.200” sleeve length.\nWorks with factory inner tie rods and factory spindle.\nSimply bolt-on. No spindle drilling required.\nInstructions with technical links included.\nManufactured with pride in Philipsburg, PA – USA\nBattle tested on the UMI’s A-Body test car.